Driver for Actuator manual

From Escape Room Supplier Wiki
Jump to navigation Jump to search
Driver for Actuator

General info[edit | edit source]

Need to manage an actuator? With the Driver for Actuator, you can control the movement of your actuator and use it in a puzzle.

Before you order a Driver for Actuator, make sure the actuator you plan to use with the Driver for Actuator and its power supply is max. 24V, and max. 10A.

Step 1[edit | edit source]

Connect the Driver for Actuator to the Universal puzzle controller using the included output relay module and an Ethernet cable.

Step 2[edit | edit source]

Connect the output set to a power supply. Then, connect the Universal puzzle controller to a power supply.

Step 3[edit | edit source]

Expose the wires from the actuator’s cable and screw them into the Driver’s orange terminal. The order depends on the direction of the actuator’s movement after winning the puzzle.

Step 4[edit | edit source]

When the Universal puzzle controller is not solved, the actuator goes in one direction (until it reaches its limit). Once the puzzle is solved, it goes in the other direction.