Morse Code sensor manual

Morse Code sensor

General info

Morse Code sensor uses a telegraph key to recognize short and long taps (“dots” and “dashes”). Make players send a message in the Morse code to solve the puzzle. They’ll love it!

The maximum load of the feeback connector is 50 mA. If you want to connect something with a higher current load, connect an external power supply - then the maximum load is 1A.

Step 1

Connect the Morse Code sensor to the Universal puzzle controller via included Ethernet cable.

Step 2

Connect the Universal puzzle controller to a power supply.

Step 3

Push and hold the red button on the sensor until its two red diodes start to blink (for about 2 seconds).

Step 4

Teach the sensor your combination of short and long taps. Look at the red diodes to see if your taps were registered as short or long.

Step 5

When you’re done, push the red button again to confirm your combination. The sensor will be triggered every time you use the right combination.