Optical Tripwire sensor manual

From Escape Room Supplier Wiki


Laser Tripwire sensor

General info

Optical Tripwire sensor activates when someone crosses its line of sight. Catch your players by surprise and activate something unusual when they pass a certain point!

Optical Tripwire sensor does not use a real laser.

The maximum load of the feeback connector is 50 mA. If you want to connect something with a higher current load, connect an external power supply - then the maximum load is 1A.

Step 1

Connect the Optical Tripwire sensor to the Universal puzzle controller via included Ethernet cable.

Step 2

Connect the Universal puzzle controller to a power supply.

Step 3

Cross the space before the sensor to trigger it. The sensor’s red diode will light up. Use your hand to check the sensing range.

Step 4

Adjust the sensing range of the sensor using the small screw on its back.

Warning: Default sort key "Optical_Tripwire_sensor_manual" overrides earlier default sort key "Optical Tripwire sensor manual".