Reflex Game extension sensor manual

From Escape Room Supplier Wiki
Reflex Game sensor extension

General info

Reflex Game sensor is a dexterity game where players have to trigger a sensor and “catch” the yellow diode. You can use any sensor you want and control the difficulty of this challenge by changing the speed of the game. The LED lights chain has 25 diodes and is included with the sensor.

The maximum load of the feeback connector is 50 mA. If you want to connect something with a higher current load, connect an external power supply - then the maximum load is 1A.

Step 1

Connect the LED lights chain to the Reflex Game sensor extension (“LED Lights chain” green terminal).

Step 2

Connect any sensor to the Reflex Game sensor extension via included Ethernet cable (“Sensor” port), then connect the sensor extension to the Universal puzzle controller (“Universal puzzle controller” port).

Step 3

Connect a power supply to the Reflex Game sensor extension. Then, connect a power supply to the Universal puzzle controller.

Step 4

There is a yellow diode on the LED lights chain that players have to “catch” by triggering the sensor when the “traveling diode” reaches it. If they succeed, the whole chain lights up and it remains won until the sensor is triggered again. If they fail, the whole chain becomes red and they can try again.

SETTING THE COLOR

Press and hold the teaching button until its red feedback diode flashes once, then release. Now, trigger the sensor to choose a color, then confirm it by pressing the teaching button on the Reflex Game sensor extension.

Order of colors: red, orange, yellow, green, dark blue, light blue, violet, white.

SETTING THE STARTING COLOR

Press and hold the teaching button until its red feedback diode flashes twice, then release. Now, trigger the sensor to change the speed of the traveling diode. The range is 1-10 seconds for the full cycle. Every time you trigger the sensor, it speeds up by 1 second.

CHANGE YOUR SENSOR EXTENSION'S DEVICE MODE

You can change sensor extension's device mode with a jumper

Every sensor extension has a set device mode but you can use the jumper (next to the teaching button) to change it into another extension. This way you can turn any sensor extension into Multi-Color, LED Progress, Reflex Game or even Color Match (with an additional RGB Button).

Change the jumper only when the device is not connected to a power supply or a puzzle controller. Please note that changing the device mode may require a different LED diodes chain or LED Light strip.