Wires Box sensor manual

From Escape Room Supplier Wiki
Jump to navigation Jump to search
Wires Box sensor manual

General info[edit | edit source]

Wires Box sensor lets you feel like an engineer or a secret agent. Cut the right wires to stop the bomb. Or connect them in a specific way to start some device! There are many amazing puzzles you can make with our wire box!

The maximum load of the feeback connector is 50 mA. If you want to connect something with a higher current load, connect an external power supply - then the maximum load is 1A.

Step 1[edit | edit source]

Prepare the Wires Box sensor and some wires (you can use the included ones).

Step 2[edit | edit source]

Use a screwdriver to put the wires in the screen-screw terminal slots.

Step 3[edit | edit source]

Connect the wires together as they should be to trigger the sensor (to solve the puzzle).

Step 4[edit | edit source]

Connect the Wires Box sensor to the Universal puzzle controller via included Ethernet cable. Connect the Universal puzzle controller to a power supply.

Step 5[edit | edit source]

Confirm the setup by holding the teaching button for 3 seconds.

Step 6[edit | edit source]

When the wires are connected correctly, the red diode will be lit.Disconnect the wires from each other and the sensor is ready to be solved.